Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: 20V Transmission 6 Speed Flywheels

+ Reply To Thread
Posts: 41-44 of 44
2012-07-03 23:29:00
#41
Originally Posted by unijabnx2000
JWT's 250mm flywheel has been sold out for a little while and they dont expect to make more until around the end of this year....

Guess that will make the decision easier...


Here is a pic for you.



and below is the link to the page.

Aluminum Flywheel 2.0, Sentra B13,B14,B15 2.0 6 speed swap vvl
Last edited by Andreas Miko on 2012-07-03 at 23-29-29.
2012-07-17 00:35:34
#42
Here are some pictures od the JWT setup.




This little part sticking out on the front of the pressure plate, on the left as pictured, is whats scraping the inside of the bellhousing. Youll see the marks farther below.



You can kind of see the marks here around the input shaft and also the work done by the starter position that is needed for the flywheel to clear the bellhousing





I just need to shave the flywheel/pressure plate mating surface and it can go in.
If I had known about these issues before I would have went with the 225mm.
2012-07-20 03:01:57
#43
Andreas, I believe this thing needs to be shaved a lot more than 3mm or 3/16" or whatever I read earlier. Did you say you got this thing to work? Could you have had a different pressure plate than mine that was thinner? When I bolted the transmission up, my uneducated guess says it looks like gonna need to be shaved about 6mm. Id like to confirm these things and I would greatly appreciate any help you can provide.
2012-08-01 03:17:00
#44
bump for some input please!
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top