Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Best 60' time on 15" slicks.

+ Reply To Thread
Posts: 1-10 of 16
2014-11-09 23:59:50
#1
Best 60' time on 15" slicks.
just curious what is your best 60' time on 15" slicks? My best time was a high1.890 that was once in a lifetime it seems. So I'm looking for this info just to compare data and make sure I'm up to par , I look forward to hearing your responces.
Last edited by Topdog781 on 2014-11-10 at 06-13-49.
2014-11-10 01:37:46
#2
Not sure what my 60' was but i ran a 12.7 at 113mph.
2014-11-24 06:26:38
#3
Thanks for the reply nupe but I'm looking for the 60 foot times on a 15 inch rim.
2014-11-27 15:39:40
#4
best 60' I have seen on the slicks is 1.60
2014-12-07 03:04:59
#5
My 60' on a 15" wheel with 22s with a bolt on VE was a low 1.9.
2014-12-14 21:09:44
#6
1.71 on 22X8X15's mt's, t25 and then again with the T3 60 trim....still spun all the way down the track on the 60 trim setup but it was all throttle control. with a 24.5" or 26" slick on a 15" wheel, 1.5's would have been possible pretty easily in my car.
2014-12-22 21:45:06
#7
Originally Posted by ashtonsser
1.71 on 22X8X15's mt's, t25 and then again with the T3 60 trim....still spun all the way down the track on the 60 trim setup but it was all throttle control. with a 24.5" or 26" slick on a 15" wheel, 1.5's would have been possible pretty easily in my car.


Originally Posted by boostednx
best 60' I have seen on the slicks is 1.60



Were these guys using traction bars guys?
2014-12-22 21:47:30
#8
Originally Posted by OptimumSE-R
My 60' on a 15" wheel with 22s with a bolt on VE was a low 1.9.


That is pretty much what I'm running now, but I have not been able to get a decent burn out in either. The Ebrake cables are crap.
2014-12-24 04:50:44
#9
No traction bars here....just es bushings and a properly setup suspension for drag....still not ideal but better setup that most
2014-12-24 18:31:17
#10
When I ran 11.31 I had a 1.8 60'. That's with 24.5x15" slicks. I spun 1st and 2nd hard though cause I didn't have any way to leave on anything lower than 19psi. So that was 19psi all the way through the 1/4.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top