Thread: Want to make me a intake manifold (low port de n/a)?

pic's? did i see something of the f/b forum about this?

Product was received around the middle of May and installed weeks later. I'm finally getting around to starting a thread with pics etc.. Ya ya I know im a slacker! Check it out under Doug's Section.

Looking for one for a low-port myself.......

Well Doug is your man for the job. I am super pleased with mine. I'm not sure if you wanted the same specs as mine? Mine has 45mm runner diameters. Id say perefect for a DE. Ve guys usually go 50mm and the plenum he would probably use is already pre made and just needs welding. So plenum would be the same (not sure on volume in liters). I use a 90mm TB (using the theory of : runner diam X 2). You also need the 3.5" intake tube (longer the better) to make the most of this setup. if you only use 3" pipe then use a 70-80mm TB.

i think dougs MIA, he maybe just really busy.. i sent him a pm a while back asking whats up but no reply.

hopefully everythings ok.

Try contacting him via FB or his number. He pops in every now and then, but he doesn't do it consistently