Want to make me a intake manifold (low port de n/a)?
Not looking for the full on custom intake, but to use the stock flange/injector bosses/runners as the starting point.
Might even be possible to weld the plenum to the end or close to were the 2 piece intake comes apart. Like the bolt on Excessive plenum idea. Now it can be welded, but would be a nice option to bolt on. This route the runners would still be quiet long (shorter than stock though). You could also cut it back to a rough legnth which would be close to the ve/n1/20v runner length.
These are just some ideas, everyone feel free to chime in.
Hopefully you can source the stock intake flange locally to you.
Making an intake for low port de's suck because of the built in water passages ugh...
Willing to pay an arm and a leg for this.
Might even be possible to weld the plenum to the end or close to were the 2 piece intake comes apart. Like the bolt on Excessive plenum idea. Now it can be welded, but would be a nice option to bolt on. This route the runners would still be quiet long (shorter than stock though). You could also cut it back to a rough legnth which would be close to the ve/n1/20v runner length.
These are just some ideas, everyone feel free to chime in.
Hopefully you can source the stock intake flange locally to you.
Making an intake for low port de's suck because of the built in water passages ugh...
Willing to pay an arm and a leg for this.