Welcome to the SR20 Community Forum - The Dash.
SR20 forum logo

Thread: Launch Control Histerosis Problem

+ Reply To Thread
Posts: 1-1 of 1
2010-09-30 08:14:30
Launch Control Histerosis Problem
Heya folks,

I am currently working on implementing launch control, and I have run into a problem.

When I input the hysteresis address 0X8082, as an 8-bit and apply correction factor of x*12.5 I get 450rpm.

Now when I try to change it and hit save, close the box and re-open it is back to 450 every time.

Any idea why this is happening? I was planning to lower it to 50rpm which I was under the impression was the lowest possible.


+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)

    Back to top