Thread: Dyno tune day *High Desert*

vid from the day.

YouTube - OSR Dyno Day 3

I had my cams at 5,300/5,700.
Looking at the graph you can see the power hop up at both points.
You can see a plateau begin at 5,200 but it's hard to say where to put the exhaust cam at.
I wonder if I should lower the switch points, maybe 5,200/5,500.

Actually on second look, torque looks like 140.
Need to read the right side of the chart.

This one was Ivans can't really compare since he ran a stock header with custom 2.5" downpipe. Cams are the same so maybe his peak in TQ should be close to yours.

I'm jealous

Hope you guys are going to the mile square park meet this weekend.

LerkZone

Don't be Jealous he has a freak motor and we have been playing with that thing for a while now.

and he needs a tune. That's why you need a Nistune or Calum RT.

I need to get me some N1 cams so I can pass up Krist.

Keep dreaming.
Once I figure out why my ECU is acting stupid, then I'm shooting for 200/160.

Hey Robert, do you have your bin file from the Dyno Day saved?
If so, can you send it to me?

I really wish he had 93 pump gas or hell even 92 pump gas out here. Could run more timing make more hp and be safe.