Thread: ground control top mounted camber plates issue

i don't know at the moment would have to measure and find out info

Correct! I hope it makes sense to you folks. I may have some pictures on when I built my set, but I will have to dig it up if it doesn't help. If not, look how the Zilvia koni 8611-race install and that will be of immense help

Goodluck gentlemen and PM if you have any questions

Also, do not forget the ring! It's a load bearing device, and without it, you have a good chance of concentration the load on the shock shaft itself, which is not ideal

do you have to make the ring?

No. The ring should come as part of the GC camber plate. Not the best design I will admit. But it's the best they could have done given the minor limitations of a top mount camber plate as opposed to a bottom mount camber plate

Now, if it didn't come with it when you bought it, you make have to fab something up (which should be about $10 in material and a few minutes with the drill and tape measure/ruler