Thread: B13 Cusco FSTB install Problem

Got my bar from the group buy yesterday went to install it today but ran into two clearance problems.
See pics below.

Cruise control module. I guess this would be a simple fix by just remounting it lower on the firewall. (same goes for the alarm siren.)



This one is a major PITA. Here my bar is hitting the P/S lines.
I loosened the part and tried to move it - no avail - the lines won't let it budge. What did you guys do?

http://www.sr20forum.com/technical-information-library/155234-how-install-your-gti-r-fstb.html

i think u have to disconnect the p/s line then run it between the opening in the bars
and who needs cruise control

As I stated on the other forum...

Had no problems with Power Steering, didn't really leak either.

Here are some pics:



I just pushed down the cruise control module, haven't seen any issues so far

Knuckleduster, will you post this information and the info/pics from your other thread as a technical thread in our suspension technical section?

Brent

Sure thing.

Wow... I didn't have to undo the PS lines. I just moved the bracket down and pushed the line a little out of the way.

Seemed really simple to me....

That was what I was planning on doing Brian, but the NX has ABS....so no room to move it that much. And that hard line didnt want to move easily for me....

so i still have a cusco fstb sitting behind my front door...just sittin

Mine is just sitting too...
I tried removing the P/S nut and couldn't get it loose! I was afraid to break something. I also tried to move the whole unit but the hard line wouldn't move for me either.

Exact same thing I did and don't have any problems.