Thread: N2K brake caliper clips

Can anyone tell me if these clips I have for my ad22vf calipers are normal. One clip has 2 rounded parts and the other has one round part and a flat part. And if they are normal, which goes where in the torque member? I have everything all cleaned up and painted and will be putting them in here soon. Just want to make sure they are correct part and have them in right. Pic below.

notice the difference:

did you not receive my reply to your PM last night, or are you creating a thread because you think i sent you the wrong parts as you stated here? either way just lmk if anything..

Brand new hardware from Napa. P/N UP 83144A

I did get your pm, and you said you were not 100% sure, and that they looked like they may have broken off. I did not doubt for a second you sent me the correct parts, please don't take the post the wrong way, I am 100% satisfied with the items I bought from you and shipping was awesome.


I started post to see if anyone knew for sure they were not broken and if anyone knew where each clip went, top or bottom.

Again, just looking for info on the clips to help me with the install.

That helps out a lot, thanks man. Only question now is which goes on top and which goes on btm? You wouldn't know that one would ya, lol.

I think I may have marked it though before disassembly, so I think I should be good.

The flat one goes on the bottom

Yup, got it now. Thanks for all replies. I got them all installed now.