Thread: Megan racing MR-CDK-NS91

+ Reply To Thread

First

Posts: 31-37 of 37

Search Thread

2012-12-06 02:45:56

#31

Zeek234

Project 91'

Join Date: 2008-05-19
Location: Freeport, ME
Posts: 422
Trader Score: 1 (100%)

Originally Posted by boriquas13

Originally Posted by Nissanb13
There not bad suspension

-

I actually like megans coilovers, it handles damn well with them the only thing I would like to add is the bumpsteer correction kit I did snap some pics today still have alot of room to go lower but I chose not too and not needed IMO. I really like how yours came out and I will say it again you have an all around good looking car you have definately captured the classic look.

Pics of coilover and axle shaft still has room to go lower with full suspension travel on the coilover, being all other variables will function normally (axle shaft, tie rod, etc).

This is decent compared to how low I've gone, its stupid and pointless as mentioned above...My boot is like centimeter away from my Ksports needless to say they're rock hard...reworking my set up this month. just dont do it.

0 Likes

Be the first to like this post.

Reply Reply With Quote

2012-12-06 02:47:20

#32

Zeek234

Project 91'

Join Date: 2008-05-19
Location: Freeport, ME
Posts: 422
Trader Score: 1 (100%)

Stock pile your ball joints and drive shafts...you'll be replacing them all the time.

1 Like

ga16eats likes this post.

Reply Reply With Quote

2012-12-06 02:48:20

#33

Nissanb13

Member

Join Date: 2012-03-26
Location: Santa Maria, California, United States
Posts: 184
Trader Score: 0 (0%)

Originally Posted by Zeek234

Stock pile your ball joints and drive shafts...you'll be replacing them all the time.

Doubt it!

-

0 Likes

Be the first to like this post.

Reply Reply With Quote

2012-12-06 03:07:13

#34

ga16eats

neew kid on the block

Join Date: 2011-02-07
Location: St.Petersburg FL
Posts: 2,250
Trader Score: 4 (100%)

Originally Posted by Zeek234

Stock pile your ball joints and drive shafts...you'll be replacing them all the time.

Truth!

0 Likes

Be the first to like this post.

b13. Trashed.

Reply Reply With Quote

2012-12-06 03:10:03

#35

Zeek234

Project 91'

Join Date: 2008-05-19
Location: Freeport, ME
Posts: 422
Trader Score: 1 (100%)

dude, I put some ball joints in, and not even a month later the boots where shit...Moog as well

1 Like

ga16eats likes this post.

Reply Reply With Quote

2012-12-06 03:39:09

#36

boriquas13 Online/offline status of boriquas13 is unknown

Member

Join Date: 2012-02-25
Location:
Posts: 173
Trader Score: 1 (100%)

Originally Posted by Zeek234

dude, I put some ball joints in, and not even a month later the boots where shit...Moog as well

This also happens on stock height suspensions as well or just plain high mileage cars, I am still on all my factory axles, ball joints, and tie rods have not replaced them yet. I do have low mileage on my car only 81k though, but I have gone through multiple set ups on suspension eibach springs/koni silvers, ground control with kyb agx, ground control and gc plates kyb agx and now coilovers. Here is a pic of my axle angles not to bad I have seen worse on lowered cars BUT..... the tie rod is whole other ball game definately need the bumpsteer kit