Thread: anyway to even out the height on rm springs?

i was afraid coilovers would be the next option lol..but i've already spent a good amount of $ on this set-up already along with swaybars and stuff...how about gc coilover sleeves?

GC sleeves would allow you to run a 2.5" diameter spring of whatever rate and height you wanted. You could get a shorter spring with maybe a bit higher rate (the AGXs can't handle too much though), but you'd still be dangerously close to bottoming out the strut. =/

i don't want a crazy drop..these nyc roads are horrible...i just want an even gap all around

Others have suggested raising the rear to get the gaps matched, but no one has come up with a tested way to raise the rear; just theories.

yeah i've read some of those i've even(flame suit on) looked into other springs and everything is more than a 1.5" drop...i think only the vogtlands were at 1.5" i've also checked h&r and they're a 1.3" drop but idk if it will give it an "un-even" drop like the rm