Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: spev v brembos to a b14

+ Reply To Thread
Posts: 11-17 of 17
2010-10-28 23:56:57
#11
Originally Posted by justin2386
Without doing much custom work, you can use B15 spindles with B14 hubs (or B15 hubs if you want 4x114.3 in which you would need B15 outer axles/b14 inner axles)


This seems like the easiest solution.
2010-10-29 00:01:17
#12
just put the b15 spindles with b14 hubs, redrill the rotors, easiest way to do it I think
2010-10-29 02:45:35
#13
B14 hubs do not work with the B15 knuckles/spindles. Diffrent sizes, wheel bearings, you get the picture. B15 CVs are also not interchangable with B14s. If you are set on doing the Spec V brembos then have a bracket made. If you use a B15 knuckle/spindle you will need to do a custom CV to match your B14 tranny to the B15 hubs.

I would look into what Scrildo said and see if the P10 or P11 knuckle could be used.
2010-10-29 15:25:37
#14
Originally Posted by zer099
B14 hubs do not work with the B15 knuckles/spindles. Diffrent sizes, wheel bearings, you get the picture. B15 CVs are also not interchangable with B14s. If you are set on doing the Spec V brembos then have a bracket made. If you use a B15 knuckle/spindle you will need to do a custom CV to match your B14 tranny to the B15 hubs.

I would look into what Scrildo said and see if the P10 or P11 knuckle could be used.


b15 2.0 axles are identicle and have the 4x114.3 bolt pattern, same with p11's. brembos bolt to those spindles without any problems. i am pretty sure that you can put a 4x100 hub into a wheel bearing of a b15 2.0 or g20. i could be wrong but im pretty sure it will work
2010-10-29 17:59:43
#15
if your going to do all that why not just slap some z32's on there. same bracket as the brembo's
2010-10-29 21:04:01
#16
Originally Posted by kaotekxe
if your going to do all that why not just slap some z32's on there. same bracket as the brembo's


cause the brembos just scream "BALLA" lol...I'm trying to figure out if I can fit a set of STI rear brembos on my rtune spec
2010-10-30 00:29:34
#17
so pretty much all i need is a bracket made and rotors redrilled to correct pattern?
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top