Thread: Strut bars with Ground control plates

True, I have this setup. But no one makes them anymore....

Can't find the grassrootsmotorsports link with the picture of the strut bar installed under the GC camber plates but the Dec 2005 issue talks about this install with a 36.00 e-bay bar.

if you have a highport or ve, i'm sure the oem fstb will work fine.

If ur worried about hood clearence it will fit with a fiberimages hood if you remeber my b13 is running gc plates with a Nissan motor sports brace mounted on top of the plates . If your running the stock hood you'll have to cut the webbing out .

Pics Tsuruser? That was a long time ago maybe I did not take notice.

I didn't clearify, you need Stillen's bar "not the plates". Shig made the brackets to adapt (not sure about other strut bars?)to the Stillen bar and G/C plates.



Yes correct!



Has anyone tried to followup from my previous post????? Shig actually might be able to help, I gave directions how and where to find him. Read below for where to find Shig! Look for "SHigSpeed".

***Hint "sr20forum.com"

If you read all of my post! I clearly state where to find help on locating some brackets.

Here's a pic I found of the Stillen bar with GC plates and Shigspeed adapters. The car belongs to Sarah Forst.

So, what strut braces would fit under the plates? Any with flat rings?

The OEM bar isn't a bulky as you think. It works well and is a relative bargain just my .02 cents.