Thread: Rear beam bushing replacement who's done it?

Got the beam out yesterday along with all the old bushings. Just about every bushing Ive taken out has had a very visible inner ring to be cut out. I do not see this on the rear. The es instructions say pop out and clean the old bushing and then the inner sleeve. Is it a small one like the large panhard was and front control arm? Or is it the big metal ring that the old rubber sat in cause I do not see a small type of thin metal sleeve. No indication line at all as I had on others. Just don't want to go too far and screw it up.

how difficult was the relacement job?

Well, it's going very well not hard to do at all. But. I'm stuck right now on what I last posted.

Im pretty sure i had to take a ring out of the panhard bushings.

Well it was the arm end link bushings. But I have since found out they have no inner sleeve. It was listed on the es instrustions as having them but it was wrong. So I will press the new ones in and hope it's an easy pressing. The panhards were simple to do.