Thread: Massive Amounts of Rear Postive Camber - Progress Coilover Install...

Ok, so I hate to make posts like this, but I've searched repeatedly for some info that would enlighten me, and I'm stumped.

I'm in the process of installing Progress Coilovers on my NX. I got the rears done and dropped the car down to find that I've got quite a bit of postive camber on both sides... I left the perches up with 3.5" of threads left below them (I wanted to start off high and dial down from there) so it's sitting with at least a 1" wheel gap. It doesn't look like both sides are off evenly, but it looks like quite a bit of positive camber - like 3 degrees or something - it's definitely excessive.

I've reread the Progress literature because I started to think that maybe the rear hats are eccentric? It didn't say anything about that though. I can't think of what else could be causing this. I figured it might be off a bit, but this is ridiculous. I also don't think it will go away that much if I dial the perches down... maybe a bit, but not nearly enough to neutralize it.

And no, I didn't have positive camber with the stock struts/springs on - it looked perfectly neutral.

Thanks in advance.