Thread: My high CR build

cant wait for some results been watching this thread..this thread is actually going to decide which route i choose so i'm crossing my fingers for you also lol..good luck and good job man

Hit a minor snag with the PS manual rack install today. I neglected to research, and I need to purchase a knuckle u joint, and tie rod ends for a manual rack, but otherwise the engine is still scheduled for start up saturday!

I'm going to be watching this thread daily for updates, i wont post much, but i'll be watching....haha. I like your N/A set up

I updated the first post of this thread with old pictures from when I first started. (originally posted on sr20forum.com)

What's your ball park figure? Must be circa 175whp?

that seemed to be around what people have estimated this setup will put out.
Nissan is overniting the steering knuckle joint I need, so everything is still looking good for saturday!

whats your rev limit on this????

hook us up with some video clip when its done.

7950 rpm using a jwt ecu. If I wanted the red line higher then that, they said that all they can do is remove it completely then I'd have to get an MSD system or something to set the rev limit.

It started!!!!

That thing sounds badass turning over. Movie and sound clips to come soon!

Hit a couple snags though,
The clutch cable is way too long, (I have a ga16 cable to put in, and am getting the reducer mod),
and the thermostat wouldn't open (a brand new stant thermo at that). So I am going back up their monday with a thermostat and the clutch cable to finish it up.

I am so excited!

I have a brand new Nissan oem thermostat if you need it!