Thread: 1995 200sx Se-R Stock Dyno (vid)

Well guys at a meet we had two weekends ago we rented a dyno.

2 pulls on a mustang dyno.

unsure how correct these numbers are but more than I expected for stock.

a little high but if the motor is a freak then it's normal. I have seen some with exhaust and intake pull 130whp on the dyno jet I tune on.

awesome good to know! thanks man...... Eventually this motor will be swapped for a ve.

Nice numbers

thanks! I can't wait to fix up the looks then do some bolt ons or something to prep it for a ve swap.

Nice HP but the torque is low even for stock. Normally around 110ft-lbs, and the HP normally about 4-8hp less than what you got which is cool.

Saw you said you are going to go VE but would be cool if you got a cheap 91 intake cam and did nothing else to the car but slap it on go to the same dyno again. I don't know if there's any dyno charts putting a highport intake cam in a COMPLETELY STOCK lowport. All the dyno charts I've seen, the lowport already had an intake, exhaust, headers, ECU etc.

If anyone was willing to donate some cams I would have no issue paying for the dyno pulls.

but yea I was expecting 110whp so 128whp is awesome haha