Thread: P12 6 speed swap on P11 drive shaft problem

I'm doing a P12 6 speed swap on my P11. I bought it with P12 drive shaft but they are too long... Bought 2 driveshaft from mazworx.
The passenger axle fit without problem.
The driver axle don't fit... its tooth are a bit bigger than P12 one.
I don't understand why one fit and not the second.

Any idea, stand it?

Get a spec v axle and call it a day. I think a couple others had issues with the p12 axles being too long.

I have the spec v axle but what i don't understand is why spec v tooth are bigger than P12 tooth? (only for driver hand)

Shouldnt be, both sides should be the same size. Unless you got an incorrect axle.

Ok thanks . I'm going to gauge it with a vernier caliper