Thread: bc0205 cams

i friend of mine but a set for a b13 but the cams say bc0205 and they are for s14 with the vct thing they had to be the bc0201 now with those cams who has set them with cam gears i put 2.5 on int adv retard exh 2.5 but the cars fills crapy the marks timing are in thier place and you can not fill the loopy idle

wwwwhhhaaaaaaaaaa?

^^^

Take them out and put your stock cams back in and see how your car runs. Wrong cam for your application.

BTW I have some BC3 if you want them

BC3's are too much for an N/A car, Joel. Not to mention he's going to need springs and retainers for them.

OP - The cam grinds (0201 or 0205) bare very little differences. If the car falls on its face in WOT, it's a cam timing issue. If the car feels fine but you're expecting a lopey idle, you need to look into JWT cams. The BC STG2 cams do not introduce any noticeable amount of lopey idle.

they lope a verrrrrrry lil bit when warm and with a LOUD exhaust....

i had bc2...sold to viperdude...and im POSITIVE the intake came had bc0205 etched into it.....

They did. It looked like the old dot matrix printers on both cams with each cam even labeled -IN and -EX at the end of BC205.

(the cams are awesome by the way, I take it to 7750 daily now with JWT ECU and stock everything else inside of that SR20DE)

post up some vids some time so i can see how it was diffrnt than my nx.... glad you like them

do i need to do shimming when installed bc0202 cam into sr20de?