Thread: HCR sr20de build dyno runs.

are any tracks open this weekend keo?

My car with a very similar setup ran 13.9 @ 98mph and the numbers you got are very close to the numbers I expected from my car....
I had my cam gears set to +6 IN +2 EX but the head was resurfaced and the block deck too... I assume that with a non resurface engine cam timing should be close to +4 0

im really curious to see what kind of change your going to see from adjusting the cam gears. im running the stock sprockets right now but i think i can get some more power out of this thing from reading this post.

New dyno! Significant increase in Tq (+10), minor increase in HP (+2).

Cam gears were set at +3 -3 for that one. Anyone have any further input? Should I advance the intake gear any more then it is or leave it?

From my understanding, when I tighten the lobes and set more overlap, that is really only going to affect my Tq, and not the HP. Correct?

Hopefuly when I finally get that 2.5" ssac header next weak that will push me up over 180 HP, and I also have an SAFC on the way that I just bought yesterday. :biggthump
More dynos coming in the next week or two!

looks like good new numbers

Why are you letting off so soon? It's still making power....

he's not, for some odd reason the place cut's the sheet off at 7k, he's revving to 8k.

Rob, I hosted the pics to everyone can see it

I like that your torque went up. Lets get this thing to 180hp and a nice 150lb ft of torque

i definitly think that the header is going to increase your exhaust flow, i also hope to see over 180 on this build, very nice!

also note that the ECU is a basic JWT tune for a C2 IIRC. with that SAFC he got, I should be able to bump acouple more ponies.