Thread: Ga16de with 2.0 ecu/ injectors

I have my Z32's MAF,Injectors,2 TB and a few bits from my NX.
Im about to start(Or try to lmao) putting aside some money for my RB so i might have to use the MAF on that engine.

My Ga went 15.1 bout 5 years ago before turbo. All i had was bolt-ons. Stage 2 clutch 8lbs flywheel pulleys CAI and header with 2" exhaust. oh also the lower gear ratioed JDM GA transmission.

my ga16de has a 4 wire maf sensor i was interested in what you did and i wanted to do it but when i went out and looked at my maf it was 4 wire do you have any ideas about that

how much you want for the throttle body

rowland manifolds. they supply the manifolds for extrudabody. through extrudabody you can get a GA16DE/S ITB setup, or for Twin side drafts by just ordering the manifold from rowland. google them, i don't have the link handy.

as for the GA section, there's recently been a new forum up, GA16forums.com. it's a good site.

and as for the ECU/injectors question, yes its already been answered, but all you need extra is the maf and you're good. the ecu provides a bit better fuel map, and is great for a basic setup.

BlownB310 first did this when he turbo'd is AWD b12 GA wagon. he didn't use an intercooler and just the basic TSI kit which only uses a T20. considering it's his ice racing car he didn't need the intercooler and didn't wanna pay out the butt for a tune. he put in the injectors, ecu, and maf, and its ran perfectly ever since.

Any updates yet?

we dont have a GA section because this is not a GA site....

Does that mean their cannot be GA discussion here?

yeah this isnt a GA site but still there is no good GA places anywhere that provides good info and there are people that have had GA for a while before going to SR20 so a section wouldnt hurt.



agreed

I agree with ya!!

Where is the Nissan Love?