Thread: Final touches of engine swap

I have one wire to figure out where it goes and I'm done.

Comes off the wheel well wall driver's side, beneath the brake resivoir, has a connector that connects to a single post/ground someplace. only about 1ft long.

Once that's connected, the very first highport obd1 engine will be started up in a b15 running on a b15 ecu and all b15 sensors.

pretty sure it runs to that little tab on the top of the tranny.

mine are all regrounded so i cant check, but if i remember right from the swaps thats the ground its for

yep, goes to the tranny. I believe its near the speed sensor.

wheres my pic of the pnp switch?

lol I thought you got one from the other guy. I'll take it tonite. It's a green connector, with about 8 small pins if that helps

no problem, green connector is all I really need to know. THANKS!

if i knew it was a green connector, i got it then lol. i took a pic of it and wasnt sure