Thread: 2013 Drag Racing Smack Talk Thread!

Is there a thread somewhere that talks about how the suspension should be to drag race?
Should the front be soft or hard? and the back?

Check the drag racing section

Yeah, there is a thread in the drag section that goes over a lot of good information.

http://www.sr20-forum.com/drag-strip/39139-how-get-b13-hook.html

Good info in this thread.

fine daily against daily cause you wont have your race car done so i will make it even

Race car? My car is far from a race car..... The car will be done and I am budgeting now to make sure I get the car there.

Trust me brother if life didn't get in the way the car would be done. Slowly and mean very slowly but surely. It's hard to build a all around car that will serve many functions. Not just a "race car"

Did you just say your bay was cleaner that Chappys?

Uh oh, look what lynchfourtwenty just posted in another thread :nevreness: :



Hehe

Yeah, remember Merlin and Searl Tate too?

Yeah I did.

His has wires everywhere and so on. Mine had nice fresh paint, everything tucked and cleaned, everything on the engine and transmission spotless. Yeah i had the holes from the old piping route but who gives a crap. Only thing I didnt have in place was the cooling plate to go between the cut radiator support. Didnt get a chance to modify it to fit. Hood doesnt count as engine bay

Oh and I also said that it will be as well when all the new turbo setup goes on, with Toxic fab FF manifold, Uppipe, turbo directly feeding into a custom intercooler with his endtanks and backdoor on the coldside using all wiggins or VanJen clamps. Yeah I think when done completely his bay wont stand a chance. lol