Originally Posted by LAM-PARK 
I have successfully interchanged B13 & B14 cables - as long as they were for the SR. The B14 cable is easier to install as it has a piece of shrink tube to prevent the connection and the pedal from flopping around.
Always replace the clutch release bearing (Throw Out Bearing) clips - they do wear and are relatively inexpensive.
Did you take any pics along the way ???
Are you able to get the car into gear with the engine off ???
|
\
>Yes - Re-adjust clutch cable, verify clutch bracket is in correct spot
-
\
>No - Inspect shift linkage, verify all engine mounts (rear especially) are alignment correctly, verify proper engine/trans alignment at mating surface.
Are you 100% sure that the 2 dowel pins that line the trans & engine are installed ??
Good luck.
Well i found the problem, it was the clutch cable and the clutch cable bracket was out of line, so redid some adjusting and the car went into gear with no problem, thanks guys for all your help
Be the first to like this post.
Back to top
