Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: GA16 power steering pump

+ Reply To Thread
Posts: 1-10 of 11
2013-03-09 04:59:23
#1
GA16 power steering pump
i have a 95 200sx SE and i want to know is there a power steering pump elimation kit for it or was there a model that didn't come with power steering?
2013-03-14 11:18:31
#2
anyone ?
2013-03-14 18:33:03
#3
I am no expert on B14,but I don think they had an"e" model like the B13 without PS.
have you tried to loop your lines yet and try to drive your car without PS?
You may want to do that before removing it....just my .02
been there
done that
...put my PS back in...LOL
2013-03-14 18:54:53
#4
Originally Posted by eggman
I am no expert on B14,but I don think they had an"e" model like the B13 without PS.
have you tried to loop your lines yet and try to drive your car without PS?
You may want to do that before removing it....just my .02
been there
done that
...put my PS back in...LOL


well the motor i have in my b14 is a b13 engine
2013-03-14 19:03:51
#5
Originally Posted by JR20DET
Originally Posted by eggman
I am no expert on B14,but I don think they had an"e" model like the B13 without PS.
have you tried to loop your lines yet and try to drive your car without PS?
You may want to do that before removing it....just my .02
been there
done that
...put my PS back in...LOL


well the motor i have in my b14 is a b13 engine


not sure what that has to do with anything???

It doent matter what the engine is...I was talking about the chassis.
2013-03-15 15:20:25
#6
Why not just swap out the pullies for a b13 e model pullies?
2013-03-15 15:47:08
#7
Originally Posted by ga16eats
Why not just swap out the pullies for a b13 e model pullies?

hmm,never thought about that...maybe the pullies are the same,and its just the belts??
Last edited by eggman on 2013-03-15 at 15-51-05.
2013-03-15 16:01:09
#8
I made a PS delete kit for my GA. I have an UR underdrive crank pulley, OS water pulley off an E model, and a custom made alternator relocation bracket. One belt FTW
2013-03-15 16:39:43
#9
The pullies are different as far as i know. Swap the pullies then run one belt
2013-03-16 14:29:36
#10
Pullies are the same as far as width is concerned. The diameter of the PS vs non PS models is different. The belt locations are diff as well.

The difference is the spacing of the alternator for the non PS models. I have a non PS bracket for the alternator that came off an E model. Both brackets for the PS and non PS models are a super heavy chunk of steel. It's something like 30 lbs hanging off the front of the motor. I made a small aluminum bracket that relocates the alternator to the WP section of the belt. I'm eventually going to make a bracket for the alternator that relocates it to the PS location and still run off the WP belt. I'm only doing that so I can run a larger DP. If you are interested in relocating the alt to the PS location, I could probably make two at the same time. Or if you want my current bracket, I could sell you that after I make my new one.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top