Thread: What Did You Do To Your B14 Today?

nice was it hard to install ?

Not at all really. On the outer rail, you have to take off and install spacers, about an inch total, otherwise the seats tilt towards the door. The mounts match up, except for the inner back one, the holes don't match up, so i just drilled a new hole into the plate and used the stock bolts and a nut to mount

nice!!! did you use a spacer on both of the seats outer rails? I've been wanting to install those seats in my b14 for a long time... Have you tried the rears yet?

yea i had to use spacers on both of the outer rails. The seats do sit a lot higher though. The passenger side i adjusted so that my 6 foot friend would be comfortable so anyone should, and on the driver side, there are more adjustment options, so it was a little easier to adjust. I would definitely put them in, but you just put in a new seat right?

I've been dying to put p10/p11 leathers in my rear but I never really had the time to make them fit.
For the racing seat, I put that in around July I believe? But I just put up the picture since it was the first decent picture I ever got of it.

I installed a ear shattering system... Bought the system off my brother and it is crazy crazy loud... It's loud enough to when you talk, it vibrates your throat so much that its similar to talking into a fan hahaha! Going to be ordering a alarm and installing it soon... Maybe friday!

Drove the car with the calum program AFRs look muuuuuuuuuch better it will dip down to 12.7 and hold 13.2.... So she defenatly feels more.peppy

Put more tranny fluid in, and put some stop leak shit in the tranny. Hoping to god it finds this mystery leak which i think is from a sensor, only leaks when parked up hill and level, but not downhill, so thinking its a sensor so hoping this shit plugs up the leak. Refilling redline fluid gets expensive.

Also after we cleaned up the garage (8 garbage bags of broken parts and shit) found my expensive radar detector i thought i let go with my altima se-r on accident. Ran the wire through the air vent, under the dash tot he hazard switchs power source and have a radar detector in my car again. Then helped ...well watched and offered advice and let josh take out his n1 cams and use my stock cams to put his car back to getting ready for his turbo build. My garage is nice and clean, ready for the 411 to show up, got the 510 cleaned up and carbs oiled and her back on the tender, everything pulled off of her that was sitting on her. By the end of the day though i couldnt change her oil, back hurt to much from standing with josh's work on his car, so hopefully oil change on the dime later this week. I really want to drive my 510, but with danny i cant

hmm..replaced the fuse in my powerstrip so now i can use my gps, charge my phone, and plug in my car topper for work this afternoon..also replaced my blower motor resister so now all 4 fan speeds work again! instead of just 3 and 4..lol

also vaccuumed out the floor in the front as well as cleaned my center console..i feel much better about it now..lol

was gonna pick up a NOS kit today..but dont have time before work..will do it up tomorrow though..this bitch will be juiced up soon!!

what radar you got danny boy?? lol jw