Thread: High volts on the maf!!!

I am having some problems with the maf for some reason its reading high volts....doese someone have an idea what can it be or what are the points to check......
My car is a b14, ve swap with b13 ecu n maf!
Sent from my HTC VLE_U

Help us help you.


What is high? 1 volt? 5 volts? 12 volts?

At key on position? At idle? At full throttle?

How did you measure the voltage?

Key on,

Sent from my HTC VLE_U

With key on position, it should be below 1 volt.
At idle 1.3-1.7 volt.

I think you are probing the wrong wires based on the pic.

The fsm shows the outer most orange wire or the left orange wire from your pic is the output wire. It's the one you should probe. Put the red volt meter probe on the left orange wire(your pic) and the black probe on the intake manifold or battery negative.

The orange wire next to the empty wire slot is the 12 volt power wire.

I also notice the wires have been spliced, could be a possible mix up?

I already did it with 2 b13 mafs but it still happened the same but when ever I put b14 maf its ok.....do u think it could be wrong connected?
Sent from my HTC VLE_U

Looks like a wiring issue, double check which cable goes where

How can I connect b13 maf in a b14? I installed baise in these info
B13 positive wire orange,negative white,5 volt Orange(inside grey shield.b14 positive,white,red,,negative,white,5volt orange! So that's correct I missing something?
Sent from my HTC VLE_U

If the wires were spliced, then most likely they were crossed.

On the sensor you have:

A- empty space
B- battery +12 volt
C- ground
D- output


Do this, remove the maf plug harness from the sensor, and turn to key on position.
Probe the wires and look for the + 12 volt wire. Once you have found it, now you can line it up with the sensor, +12 volt wire to B pin/terminal on the sensor.

We tried that already!

Sent from my HTC VLE_U

Hmm, I probed my pigtail tonight on a b13 wired for my n62 MAF that I'm trying to single out. Code 12 and 0.01% in diagnostics. N62 is A-F with only B-E in use. I got anywhere from 10.9-18.8. Key was in the on position. Maybe I did something wrong? I actually got reading from the ground which struck me as odd.