Welcome to the SR20 Community Forum - The Dash.
SR20 forum logo

Thread: VE engine harness question

+ Reply To Thread
Posts: 1-4 of 4
2013-03-27 01:48:55
VE engine harness question
Hi everyone,

I have a question regarding my VE engine harness. I'm about to put a VE into a B13 Sentra. I've got the engine wiring harness all plugged into the proper places on the engine and was just going over all the plugs that will go into the chassis harness. I think I've got everything figured out except for these two plugs circled in red below:

The MAF plug is right above the two circled plugs and the three plugs near the wooden blocks go into the the bracket that's near the frame rail.

But what do these two plugs go into? I've looked at the empty engine bay and can't find anywhere where they'd plug into.

Any help would be appreciated.

2013-03-27 02:12:52
Is that the b13 harness?If so,then 4 prong one is for the distributor and the 3 goes to the ignition coil.
2013-03-27 11:58:53
O2 sensor and distributor
2013-03-27 14:39:59
Great !! Thanks for the advice!! Much appreciated.
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)

    Back to top