Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: Modified sr20ve intake manifold

+ Reply To Thread
Posts: 71-78 of 78
2014-03-06 19:23:49
#71
Originally Posted by kyoshoboy
Very nice build, any update on this?


I don't have any before and after figures, but u have some dyno comparisons to other vvl's on the same dyno. Bear in mind the figures aren't comparable to your dynos, and were at very high altitude which adds a further 17% loss.

First up is a n1 ve with usual bolt ons.



87.5mm ve with kelford 184c and itbs



88mm ve with the modified intake.




Tuner is a bit apprehensive to tune past these rpms and I want to go to a smaller cai. I believe the 4" cai looses hp.
2014-04-15 18:59:22
#72
We did something similar. Added 30° 70mm elbow and 70mm TB. Manifold was cutted and ported.

2014-04-25 15:11:44
#73
Damn and that modded ssac...nice
2014-04-26 23:28:33
#74
Yes, followed other members proven mods to SSAC primary. Kind of budget mod...
2014-04-27 18:07:59
#75
check out mahhhhh header!!!!!!!!!!!!
.

.

(since you guys mentioned one I just took this yesterday with the radiator removed, rare look at it installed)
2014-04-29 02:26:41
#76
DEF gonna buy a q45 TB now
2014-04-30 23:23:02
#77
Originally Posted by Storm88000
check out mahhhhh header!!!!!!!!!!!!
.

.

(since you guys mentioned one I just took this yesterday with the radiator removed, rare look at it installed)


who makes it?
2017-01-30 00:47:58
#78
@mercado ser
Last edited by karibah on 2017-01-30 at 00-50-35.
+ Reply To Thread
Quick Reply
Thread Information
There are currently ? users browsing this thread. (? members & ? guests)
StubUserName

Back to top