Thread: need help code 11

code 11, cam angle sensor circuit. Well my car been sitting for about 5 months now, I still got this problem, I changed distributor. Same problem runs, then shut off about 10 mins . Engine Code 11. Won't start right back up. Maybe faulty distributor again. Anything internally in the engine cause this? If not whats next to check? Bad wiring? Timing could be off? Really want to get car back on the road.

bump

Now how does it run when it's running. Also have u removed the dizzy cap and looked for oil in iii

Check your actual connection plug. My friends 240 died this weekend, same code, we drove it to the junkyard (some weekend scavenging) and then it wouldn't start. So we fiddled with everything we could and found that if you jiggle the plug on you could here the relay switching. The plug has a pin that was not making contact, bent the contact inside the plug back so it made actual contact with metal plugs.

When it runs , it runs fine, So I should start the car let it run, then when it shuts off. Wiggle the plug and listen to the relay to click and see if it starts back right.

It is a brand new distributor, i changed it out. But still have the same problem. I didnt check the connector as yet.

Tried to start car last night, still didnt start up. I checked the connector and it looked good. What else should i check for?

Do you have a remote start alarm installed?

Peace

Yeah i do, But i do, but i think it wont shut the car off if its running, and i had the remote start on for couple years.

Ok. Maybe the remote start alarm was wired a particular way that keeps fucking your dizzy.

I have had tonnes of dizzy issues, most recent of which was caused by a remote start alarm that was inappropriately wired and fucked my dizzy 3x.

The previous times were when I had a Greddy Emanage blue piggyback that somehow was causing dizzy to fail as well.

Look into how your alarm is wired. If a wire goes straight to the dizzy, that MAY be your problem.

Good luck.

Peace