Welcome to the SR20 Community Forum - The Dash.
Register
SR20 forum logo

Thread: compression confusion

+ Reply To Thread
Posts: 1-8 of 8
2012-12-13 13:59:13
#1
compression confusion
I just received my 16ve crank yesterday and am having it knife edged today. My question is what compression ratio will a 16ve crank and pistons net in a de. also, would I have yo use 16be rods because of the length difference
2012-12-13 14:07:41
#2
About .6 cr lower than ve iirc
2012-12-13 14:14:47
#3
0.6 to 0.8 point lower I think...

Peace
Last edited by niZmo on 2012-12-13 at 14-16-22.
2012-12-13 14:17:57
#4
Yes use the sr16 rods.
2012-12-13 14:38:36
#5
If I don't use the 16be rods the comp would be way to low correct?
2012-12-13 14:48:59
#6
Originally Posted by ga16eats
If I don't use the 16be rods the comp would be way to low correct?


Good question...

Peace
Last edited by niZmo on 2012-12-13 at 14-49-37.
2012-12-13 15:01:57
#7
If you use sr20 rods on a sr16 crank the pistons will sit way below deck.
2012-12-13 15:29:59
#8
About 17 mm to low I'm guessing. crap. now I need to find rods
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)
    StubUserName

    Back to top