Greddy MSS RPM reading issue
Okay well, solenoids kick in no problems, but i notice that once it goes over 6.2k or so my RPM reading takes a giant crap and sometimes goes to 0, or just lags intensely. I have reground the MSS with the only result being that the difference between the tacho and the MSS wasn't a giant amount (before : if tacho was 6k, MSS would be 5.6, now it is within 200)and i currently have it taped into the tacho signal wire from the ECU.
Any ideas? As i was leaning towards trying the - side of the coil, but i have heard people having issues with this too
I have been using this pinout, and using pin 2
Any ideas? As i was leaning towards trying the - side of the coil, but i have heard people having issues with this too
I have been using this pinout, and using pin 2
Last edited by naedtrax
on 2012-05-01
at 11-56-59.