Thread: Where to set rev limit ...

I am sure most of you are familar with my buld , so I was wondering where you would set the rev limit on it .....with the 20ve cams with BC springs and retainers , we are installing them tomarrow , with the GT35r , I am sure we will make power deep into the rev range so just though I would throw this question out there I was thinking 8.5K or possibly 9K thanks for the advise , I know at 7.5K she still was no where near the topof the powerband

http://www.sr20-forum.com/turbo/16953-mazworx-sr20ve-sr20det-project-2.html#post304819

going from what mazworx did with there s13vet i would imagine some where around 8-8.5k. i know its not 100% the same as yours but it a start.

Why not just do some pulls then figure out where to set the limit after you see your curve? id go higher till after you all done on the dyno. Then set it to where makes the most sense

This is about what I was thinking .....I was going to rev it a little ways past where it peaks in power, to give it some over rev at the track