Welcome to the SR20 Community Forum - The Dash.
SR20 forum logo

Thread: Ported N1 intake manifold, *pics* and flow data

+ Reply To Thread
Posts: 61-61 of 61
2017-01-30 01:03:42
Originally Posted by snickers
So i've done a few of these N1 manifolds, cutting them open and porting them out. I've done probobly 4 by now and each one gets better. You have to weld them up in a few spots to add material and strength before cutting open and porting. I took a few pics of the manifold next to a stock n1 lower runner section as well. This was before i finished "prettying up" the inside of the manifold.

Here is the flow data. (all #'s at 28")

Stock N1 intake manifold flows 275 CFM
Stock VE Cylinder head, flow @ .500" valve lift, with Stock N1 intake setup 226cfm

The ported N1 manifold before welding the plenum on flows 391cfm, after welding it on, they drop to about 375 cfm average on all 4. low of 371, high of 378.

The ported head that I have (done by someone else, not me) flows 280cfm @ .500" lift... With this ported N1 intake manifold bolted on the flow drops from 280cfm to 274-276cfm. Only 4-6 CFM drop which is awesome. A correctly designed intake manifold can actually increase the "total" cylinder head flow if the taper and design are correct.

Anyways, here's some pics... thought i'd share....

@mercado ser
+ Reply To Thread
  • [Type to search users.]
  • Quick Reply
    Thread Information
    There are currently ? users browsing this thread. (? members & ? guests)

    Back to top