Thread: New VE thermal spacer by Thermalnator

I know there has been some talk as to if we need use all 3 gaskets supplied in the Outlaw thermal kits or if we can just use the 1 that moves the ITM off the block. The shop where my car is has these for sale. This is the manifold to block gasket only as apposed to the TB, plenium and block gaskets. These are great for those who are looking to just move the ITM without bothering anything else. The seller is asking $50shipped If interested 410-633-1571 and ask for Brian or Ray

http://i79.photobucket.com/albums/j123/JDMFresh/DSC_0614.jpg

http://i79.photobucket.com/albums/j123/JDMFresh/DSC_0617.jpg

http://i79.photobucket.com/albums/j123/JDMFresh/DSC_0614.jpg

In case some prefer E mail [email]brian@ma-motorsports.com[/email]

What about extended studs?

Dudeman

Longer hardware is not needed.

do u need to use a gasket when using this spacer?

assist

advantajes of using that?

lower inlet temps

I would say there are two very important spacers. The one between the intake manifold and the block and the one between the intake manifold and throttle body. Reason I say Throttle body, because basically all cars have a coolant heater running through the throttle body to prevent icing.

Now at $50 this is a pretty good deal, but remember that at Outlaw you are getting 3 spacers and all the hardware to extend the bolts etc for $125 or if you get in on a Group Buy $108 shipped.

So you take this guy out to make a shameless plug for the GB? Thats shady....lol