All posts where OnTheChip has been mentioned by other members.
can 9.1 ohm injectors be ran on the nemu?!?
Thanks D-Unit121. OnTheChip and JKTUNING , can you also chime in when u get a moment...?
Bug: Triggering download with keyboard
so we are almost 100% sure its a software bug....... the fan functions no longer work and live data no longer works and the software crashes super easy. We are using two different computers and it ...
JKTUNING OnTheChip
a friend an I started looking at some logs a little more closely, and we think the ecu is trying to compensate for a lack of an 02 sensor since I am not running one. and we all know the 02 is main...
From what I have read its mainly hardware changes and the addition of "Flex Fuel". OnTheChip JKTUNING.
JKTUNING OnTheChip
UPDATE:
So after figuring what latency for the 800cc injectors, I inputted them into Nismotronic and alas, the car still wouldn't idle. So with this, I sent John my file and low and behold, I was ...
were the classes ever recorded?!?!?!?!? JKTUNING OnTheChip
Thanks for the tip ebinkerd, I am waiting for a shipping estimate now.
OnTheChip
This one will work right? There are no numbers in the field where all the supported ones are listed, but google ...
JKTUNING OnTheChip would it be possible to make it so the radiator fan stays on for a while after the car is shut off? either by time or maybe by temp?
another thing.. since the aicv isnt neede...
You would have control over it with the SA version, but with the older stuff it is hard coded and you won't be able to change it.
The max RPM for sure cut is likely 6300 or 6400 RPM, which isn't...
93 b13 using a p10 ecu
I have a couple quick question just to verify I'm doing this right. JKTUNING OnTheChip When wiring the IAT to the EGRT you just cut the plug off and wire in wire to wire ri...
This makes me want to take my sfac and current ecu and throw it in the trash lol.
Thanks again for the generosity. I remember all the excitement in the room when we called the winner for this pr...
This is going out today for the raffle!
I hope to make it this year, but I am still not 100% sure.
http://www.j-k-tuning.com/NismoTronic/NismoSA%20Raffle.jpg
OnTheChip marksr20
EBC setup -- (ecu based boost control)
Cranking problems with Code 11 - Crank Angle Sensor
If you don't have 12V at ECU pin 46 at all times, the ECU will "forget" the "set launch" rpm setting and revert back to the default launch rpm setting on the Nismotronic LIMITERS, REV LIMIT SETUP s...
Update,
Took apart the distributor to see if any oil had gotten into it. Found only a small amount on one of the screws inside. The disc was not contaminated. Cleaned up and assembled it. Don't kn...