All posts where karibah has mentioned other members
Hey Y2KG20! Thanks for the response.
I did some research and got my answer; R35 injectors are a direct fit in a 8H6 (P12/T30) cylinder head.
U13 SR20DE: Needs advice on exhaust
You're using the 32bit ECU PuPPiesOnAciD?
zeneffect, changing the whole knuckle is the only option now?
Is there any other machinist that can do this?
Thanks Sal_JapMechanic; waiting to see that build thread of yours.
I'll help as much as I can throughout your process :bigthumbup:
That was my thought exactly eric96ser. My question now is:
Do I NEED the corresponding pedal and M/C? Can I use the Maxima clutch pedal with the B15 M/C or does it have to be B15 Pedal & M/C?
I don't want to damage the restrictor inside of the M/C if I machine it. I'm very meticulous and would prefer doing things the right way with the least amount of hassle.
Thanks zeneffect . I'v...
Doesn't thread flush into the port; the fitting is tapered zeneffect.
Those types of components use the below fittings but I didn't have clearance which is why I bought the 90*. I know if it do...
Not to resurrect and old thread but I've been trying to find out some info on this too. After reading the posts from NI SER-1 and ashtonsser, its a lot clearer now. My only problem is that I can'...
Not to resurrect and old thread but I've been trying to find out some info on this too. After reading the posts from NI SER-1 and ashtonsser, its a lot clearer now. My only problem is that I can'...
Vadim, the links for the pics are broken. Help!!!!!
:rofl: @ sausage fingers morgans432
I used to like it too 1fastser :rofl:
Things didn't work out on that end but on to bigger and better; just like my build.
I have the OEM hard lines running to the back but SS to the calipers in the rear and i'm making braided lines for the front. Fuel will be all braided though DaveM.
go for it mickey'SE-R!!!!!!! SILVER FTMFW!!!!!!!!
I was swinging on the damn bar after i bolted it in mickey'SE-R. I can foresee that the rear is going to be extra rigid with the 19mm rear sway bar, rstb, pillar bar an floor brace.
I have to update this thread from the "What you did to your B13 today" thread.
Updates:
[url= URL=http://www.sr20-forum.com/sentra-se-r/39341-what-did-you-do-your-b13-today-77.html#post973035...
I just might zeneffect. I'll message you.
Installed my Active Tuning RSTB from bartown
http://i1082.photobucket.com/albums/j374/karibah/B13%20Build/B13%20Project%20Progess/20140510_173153.jpg
and in doing so I had to remove the rear se...
Got my Active Tuning RSTB from bartown
http://i1082.photobucket.com/albums/j374/karibah/B13%20Build/20140510_163926.jpg
There is 9.8105 and 9.8106 alki24. I went to [url= URL=http://www.energysuspension.com/products/Sway-Bar-End-Link-Bushings.html]Energy Suspension[/url] and scrolled down to the section of the page...