nismo_star's Likes Received

tq head on block on engine stand, flip block over, and check bores w/ bore gauge 3.405-6" in 8 places per cylinder or have machine shop check it. I think you are looking way too far into it, I'd b...

tq head on block on engine stand, flip block over, and check bores w/ bore gauge 3.405-6" in 8 places per cylinder or have machine shop check it. I think you are looking way too far into it, I'd b...

gtir uses resistor box. is it present ? also TPS wires are reversed on gtir.
My B13 used to run Power FC RNN14, I had issues until I was able to figure out latency values, which were affected by ...

most people dont have access to a degree wheel and know how to use it properly

Testing with demo Miller Syncrowave 250DX AC Pulse 60-100A 18cfh argon, HTP 3/32" 1.5% zirconiated, HTP 1/16" 4043 rods, cleaned with acetone, Hitachi koki drill press, MSC 3.0" hole saw MSC 2.5" h...

The manifold I made a long time ago, creep is fine (money car) the original downpipe was destroyed when it spit a rod, old block had webbing cut. I was asked to not cut webbing, and make a new dow...

Making a dream happen for one of my friends, not the easiest thing to do but when done, I hope he's happy with the results.
Material Used: Stainless Steel, Burns 321 4to1, SPD flange, ARH reducer, ...