2_Liter_Turbo's Likes Received

Looks good Leng!

Read most of it the first time, just not the last few posts (go figure). Still not real clear as to what it is, but I guess it doesn't really matter anyways, lol.

It was on a Mustang Dyno, which is typically called a "heartbreaker" dyno, because it reads lower than most if not all of the other brands. It's also one of the more accurate dynos, lol.

It isn't my favorite either, but I loved my old '75 B210 Honey-Bee I used to rally around, ha ha.

I Was Selected for a Street Car Challenge (Video + Article)

I Was Selected for a Street Car Challenge (Video + Article)

The only one running drag tires at the event was the RX-7. We had one choice of tires to carry us through all events. I chose direzza star spec IIs. I kind of wish I would have ran my MT DR's, ha h...

I Was Selected for a Street Car Challenge (Video + Article)

Welcome to the forum!

I think you have that backwards, lol. Draw through setups are between the air filter and compressor (stock style). Blow through setups are between the compressor and intake manifold.

A small update to the GF's car, lol.

I picked up this Stillen B15 Catback Exhaust (made for a Spec-V, but going to mod it to fit) for super cheap off Craigslist. Actually not going to install it u...

That's pretty awesome!

Racing the S13: 2013 Bible Creek Hillclimb

I Was Selected for a Street Car Challenge (Video + Article)

Lol, the car looks a lot better in pics and video than in person. The chassis is pretty tired and worn. The S14 is stiffer, has better suspension geometry and has more room for tire up front than t...

I Was Selected for a Street Car Challenge (Video + Article)

I Was Selected for a Street Car Challenge (Video + Article)

I Was Selected for a Street Car Challenge (Video + Article)

I Was Selected for a Street Car Challenge (Video + Article)

Figured out yesterday (finally!). It turns out that when I had the engine harness done back in 2005, that the people who did it had the ECU, o2 Sensor, and two other wires all powered off of one sw...

Figured out yesterday (finally!). It turns out that when I had the engine harness done back in 2005, that the people who did it had the ECU, o2 Sensor, and two other wires all powered off of one sw...

I can definitely vouch for their quality fabrication work! I was very happy with the exhaust work on my Celica Alltrac, and looking forward to getting more stuff done on the P10 and S14 :)

I will vouch for their quality fabrication work. I had exhaust work done by them on my Celica Alltrac, and it was top notch!

I can definitely vouch for their quality fabrication work! I was very happy with the exhaust work on my Celica Alltrac, and looking forward to getting more stuff done on the P10 and S14 :)