Yes I used a Honda b series tri-y header to make it. I just picked up a b14 and will be swapping all the na parts into it so I'll have more na posts in the near future.
Yes I used a Honda b series tri-y header to make it. I just picked up a b14 and will be swapping all the na parts into it so I'll have more na posts in the near future.
Well after the tranny breakage I have been busy collecting parts and swapping stuff out. As you can see here I pulled the stock trans out (note the huge hole) and placed it next to my ne...
Nothing posted on this forum could ever make me mad. I've just noticed a lot on naysaying here and it's getting old. Like I posted before I'll be going to the track Friday if the weather holds, let...
Well I'm not going to argue what is possible or not. My ve pulls great and runs like a charm. I'm not the only sr20 car using this Dyno and the hp #s have all been spot on. Thanks for looking but i...
Well went to the Dyno today. Car did very well. 202whp 160ftlbs.
Mods
Custom tri-y header
Modified intake manifold with q45 tb
3in exhaust
6 puck clutch 8lb flywheel
Nismotronic SA ecu
I have the first ipad(no camera). I can enlarge the pic for you guys, give me a bit as I'm lazy. I measured the in diameter of the sr20 ve manifold at its largest point 2 7/8 and carried this diame...
Well I'm not going to argue what is possible or not. My ve pulls great and runs like a charm. I'm not the only sr20 car using this Dyno and the hp #s have all been spot on. Thanks for looking but i...
Well went to the Dyno today. Car did very well. 202whp 160ftlbs.
Mods
Custom tri-y header
Modified intake manifold with q45 tb
3in exhaust
6 puck clutch 8lb flywheel
Nismotronic SA ecu
Nothing posted on this forum could ever make me mad. I've just noticed a lot on naysaying here and it's getting old. Like I posted before I'll be going to the track Friday if the weather holds, let...
Well went to the Dyno today. Car did very well. 202whp 160ftlbs.
Mods
Custom tri-y header
Modified intake manifold with q45 tb
3in exhaust
6 puck clutch 8lb flywheel
Nismotronic SA ecu
Well went to the Dyno today. Car did very well. 202whp 160ftlbs.
Mods
Custom tri-y header
Modified intake manifold with q45 tb
3in exhaust
6 puck clutch 8lb flywheel
Nismotronic SA ecu
Well went to the Dyno today. Car did very well. 202whp 160ftlbs.
Mods
Custom tri-y header
Modified intake manifold with q45 tb
3in exhaust
6 puck clutch 8lb flywheel
Nismotronic SA ecu
Ok sounds good. My header is just about spot on with the link you posted and I should be able to make the intake manifold, I just need the fab parts. I'll start collecting parts and see if I can ha...
First pic is your start solenoid wire (the plug end has a matching plug on the chassis harness, while the stripped end should go to the starter,on older starters this is crimped in place.) 2nd pic ...
Contains unread posts
Contains no unread posts
Thread is closed
You have posted in this thread
Back to top