Storm88000's Likes Received

One of my B13s had that issue with the radio and dome light going off randomly at the same time, IIRC it was just a dash fuse that needed higher amperage ..

We have a second house in Myrtle Beach. If I can swing stopping their on the way down and back I'd be down for the road course. Just got Megan coilovers in the B14. But I need more power!

And a bad pulley will also eventually separate while your driving down the road- usually when you're @ WOT. It happened to me in my 97 SE-R. Saw the outer ring bouncing down the highway behind me

Again, I just did both hoses from under the car. Mine is a lowport though. Is it more difficult on a high port?

Here's how I removed the small hose:

http://photos.napalm.net/clubsi/IMG_4673.JPG

...

WOW! Found this in storage. For the true old schoolers

Branden, clean!! Like it a lot. Don't see many in white

Is the clutch disc facing the correct way?

WOW! Found this in storage. For the true old schoolers

WOW! Found this in storage. For the true old schoolers

WOW! Found this in storage. For the true old schoolers

Nah haha. I think that it's the original bearing at 200k- all that moving the axle and hub around probably did it

Thanks Ian!

Ok so I slowly jacked up the trans with the shift linkage connected. After about an inch, the shifter in neutral now sits MUCH closer to normal. I just have to get under there tomorr...

Got it. Thanks Lynch. I will mess with it when the weather clears up.

No since Todd left Saturday I put it together myself. Haven't had anyone else here to help.

I removed both the shift linkage and shifter stabilizer bar to remove the gearbox.

And to answer your o...

Thanks Ian!

Ok so I slowly jacked up the trans with the shift linkage connected. After about an inch, the shifter in neutral now sits MUCH closer to normal. I just have to get under there tomorr...

No since Todd left Saturday I put it together myself. Haven't had anyone else here to help.

I removed both the shift linkage and shifter stabilizer bar to remove the gearbox.

And to answer your o...

Storm88000 problems

Storm88000 problems

Storm88000 problems

Sheetz stomps Wawa :) Sheetz has slowly taken over the state, Wawa has it moments tho :)

And BTW, to the OP - that red NX of yours is one of the cleanest I've seen ever. Great work :bigthumbup:

On the way to the convention, stopping for some goodies:

http://img.photobucket.com/albums/v87/Storm88000/Storm88000150/cleanwal_zpsunkqlua4.jpg
.
http://img.photobucket.com/albums/v87/Storm88000/...

On the way to the convention, stopping for some goodies:

http://img.photobucket.com/albums/v87/Storm88000/Storm88000150/cleanwal_zpsunkqlua4.jpg
.
http://img.photobucket.com/albums/v87/Storm88000/...

Ray Kawski is one of the most generous, honest, and helpful guys ever in the SR20 community. He's right up there with Mike Kojima and Chris Scarpulla. He's helped me out for years and countless ot...

Make sure you get some earplugs :)