It was no. BUT as usual you keep asking until someone agrees with you. That just isn't going to happen this time. Let's recap some highlights, shall we?
Keo, I dont know you personally but you are a respected member here on this board and I think we can both agree that's a little far stretched from the truth. There are definitely members on this bo...
It will have to exist in the classifieds (which is apparently too much effort to visit already), and it will have to be maintained by someone which puts more load on someone. I nominate Topdog for ...
Too much work to check the first couple of threads in each Vendor section, and then go check the first couple threads of the Group Buy section to find the i...
You might have an problem with ODB2 ... I have been looking into making MegaSquirt PASS with an OBD2 Simulator that sends out clean to all systems and CANBUS will display the realtime engine RPM an...
Comparing a fwd car made to be an econo, luxo sedan to a awd car designed to be a sporty WOT car in autocross? wow! Pick a better fight.
I don't know anyone that has ever thought the P11 was an a...
so basically the updated the material, but didn't change the length to have them bottom out properly in the block? may be worth the extra $$$ to go mazworx.
On aluminum I always use a razor with light pressure and for the grooves I use a small screwdriver with pressure and it comes right out. On the lower metal pan I use the wire wheel on a porting too...
Just clean it up really good and throw a VET head gasket ($75) and ARP head studs ($140). Good until the rods bend... Both are reusable after you pop the engine too :)
More progress. I modeled the shifter stabilizer flange in Solidworks yesterday while waiting for the bender die. I cut it out, tacked it, and test fit it tonight. After a few tweaks, it's going to ...
Thanks for the interest everyone :) Right now I'm focusing on the fixture fabrication so I can pick up on the OEM mounting locations, which will make it easier to reproduce them for ya. I'll try a ...
The whole point of this is to stop grinding and hogging away material that cannot be put back again. I had to have my P10 arm ground away to fit (a thank you Manny) and it works. It feels differen...