All posts liked by Keo
I work Thurs & Fri till midnight and Saturday till 6 pm. Driving during the night Saturday for the picnic / swap meet / car show and to be able to see old friends. The plan now is to drive back h...
About 99% complete with this thing. Going to install this weekend and retune... Finally!
http://s15.postimg.org/bk7z8fsi3/image.jpg
aimlessly coming from FL to the picnic...wherever it is.:rofl:
Fly to CT.
Wander into Marsh Tuning/Morpheus Performance.
Take my keys, go inspect my car, check out the exterior, engine bay, trunk, exhaust and interior. Slip into my new mint 370Z seat(s)...
These are right up your alley.
I thought it was obvious but I guess just to everyone else.
The ve is the way to go but if you want to go crazy on a de I say do it go back to the old school way and kill it with a de
Picnic location? Trying to map travel routes now.
COLOR MATCHING HEAT SHRINK TUBE. MUST HAVE ALOT OF TIME ON YOUR HANDS FOR WIRES NOT SHOWING LOL. :bigthumbup:
Now running Nismotronic and 3" exhaust system.
Ran a 13.1@107mph on street tyres
This is a centre fed intake manifold Im working on for an N/A VE, currently in mock up stage.
Going to be tight to clear the hood!
http://i129.photobucket.com/albums/p232/daleberridge1/Mobile%...
They will be coming very very soon.
Dave and I have both been testing them in our personal cars to ensure that the functionality stays the same or very very close to the V1 boards.
A lot of t...
I dont think they are that low comparing that he is running 8.5:1 compression.
The 9.5:1 would get higher HP at lower boost, I know the difference between the 2 because Ive had both kinds of tu...
There is an older guy that claims he has three NXs. I have seen two of them so he probably does have a third. I tried to buy one, he just could not sell any one of them, he likes them that much and...
Drove it for the first time in nine months....
Shady's links/arms assembled and test fit...,they're good to go and going out tomorrow via UPS :)
http://turbofx.net/wp-content/uploads/2015/05/Nissan-Lower-Control-Arm-Fabrication.jpg
I'll r...
After market glass run and door weather strip for 2 door B13 on ebay
Keo is right, I pulled the clutch pedal from an 03 Maxima and it was exactly like you have pictured. 2 bolts holding it up top.
I skimmed through the thread but from researching and getting ready...
Ok I used 1999 p11 everything from lsd tranny, pedal, Mc slave reservoir, I made the 3rd top hole wider on the pedal to the stud inside the firewall and fit nice on my b14 I left the firewall botto...
NismotronicSA is now running on the bench setup. I'll post some pics soon. I expect to have full functionality this weekend as well as wiring my 00 p11 up I'm a dual ecu setup. PLUS the first profe...
1991 nissan sentra se-r 55,000 miles trade
all these low mile ones popping up
More manifold fabrication progress...I'll be porting it tomorrow. So far, I'm digging the Mazworx sr20det/ve flange for 1.25" schedule 10 pipe, the oval to circular transition works well :)
Run...
I apologize if the internet is making this seem as I am"coming at you".
Lets be clear. I am not accusing you of holding back anything. I am asking you to share any info you have that may make it e...
She looks purrty!
I'll give you $7400 for her...deal???
Too soon??? Lol