All posts liked by Lynx
1 |
Dala's board is built and tested. Will be shipped on Monday. Took longer than expected to get it built due to some revsions but it works as intended. Lynx let me know if you want one I can have ano...
When a successful thread like this is started, the original poster does 50-90% of the leg work themselves. They get the ball rolling with some serious research of their own, and let others fill in ...
Since the Inovate wideband is supported as a serial input(direct wideband), it should be possible to support added ADC via the MTS log chain. So if u added a SSI-4 or TC-4 or LMA-3 to an existing I...
These are VW coils found on the 2.0T motor. They cost about $20 a piece, this set I got for $70 with the harness at the Pick and pull in Va Beach. But thes are a 5v pull up style coil just like Nis...
Finished welding last night. All that's left is flange surfacing, a light porting, and some deburring.
http://turbofx.net/wp-content/uploads/2015/04/TIG-weld-pie-cut-exhaust-5.jpg
HOW TO: Delete Waxstat Cold Idle Mechanism (VE)
Hey All,
I have 1 set of B13 arms and 1 set of GTiR arms in stock! I made a few extras during the last fabrication run.
P.S. I filmed ~40gb worth of video clips during this last control arm fabr...
Thanks Lynx...i've been thinking of your offer and will get back to you.
And for those watching, I'm bringing this manifold project back up to speed! I have ordered more materials and started work...
Built another set of B13 Rears for a forum member last weekend...think I'm going to photograph all builds from now on :D
http://turbofx.net/wp-content/uploads/2014/08/Cutting-Chromoly-on-the-Ban...
1 |