All posts liked by dganic23
1 |
Who's still spraying??time slips inside
Add a VET head gasket and some good head studs with a good tune and nothing less then a 100.
i had a girl throw change at my gf car while i was driving. I chased this hood rat all over town and called the cops while i was in hot pursuit and they took care of the rest. this girl throught sh...
you need to follow the oem pattern for the head studs. the torque steps seem fine. make sure to tighten the studs to 12-14in/lb in the block before putting the nuts on. also use the lube that comes...
new setup 6262 trackforged top mount t3
535whp and 380lbft @22psi
[url= URL=http://s31.photobucket.com/user/cortrim1/media/dynowhp31214_zps0903ca0a.jpg.html][img]http://i31.photobucket.com/albums...
Its not hard... I'll have a write up when I finish my p10 over the summer
Sent from my SAMSUNG-SGH-I317 using Tapatalk
Heres a vid of the event..
http://www.youtube.com/watch?v=BqO1C3UDNxQ
Shows Bes' 10.8 run..
[url= URL=http://s1019.photobucket.com/user/sr20boosted/media/B14%20Build/DSCF0362_zps77ba51ac.jpg.html][img]http://i1019.photobucket.com/albums/af312/sr20boosted/B14%20Build/DSCF0362_zps77ba51ac.j...
good god that front mount is sketchy
http://i3.photobucket.com/albums/y89/Bes_SR20/ngbbs4b12b061836e1.jpg
<3.
Final 723 at 29 pounds
333 at 7 pounds at 7500
I really don't see where you are rushing for the important aspects. You are taking the time and putting in work where it counts. I wouldn't even care about the hood. Looks good man. Its almost star...
1 |