All posts liked by freakflier
Thank you Dala. You can stand those T0-220 components up right, I pushed them down for shipping.
This is very much a prototype/ test board due to the addition of the prototyping area on the righ...
My SR20/KA24 Engine Run Stand
According to Nissan.com.mx the curb weight of a "loaded" 2017 Tsuru GSII is 2176 pounds. According to Edmunds a '94 5 speed E sedan was 2346 (a '94 GXE sedan was 2438). Corners cut.
Got it, i put the case on and everything was smooth like butter, the case will steady to top of the shift rods quite a bit.
found my problem, im missing the interlock pin inside of shaft # 2 . ugh who knows where that thing is : /
Well it has been awhile since I have done any work to this, till recently.
Got it in and i was able to get it to run. Still have plenty to do to get it right.
Different intake(mine has no plac...
Open Hardware COP controller
#2 so you have consistent fuel pressure across the fuel rail.
It all sounds like a bad idea. You need to leave the blow off installed. Just get a recirculate nipple fitting for your HKS and recirculate or switch over to blow through. You are blowing off mete...
Excellent. Worst case I try that and the fan doesn't spin any faster with these. I've got an ammeter ordered that will let me check current up to 100a, so I should be able to get good numbers onc...
Buy some crossmember bushings from unisa jecs while your at it. The rubber stock ones in the crossmember are probably worn out. These are aluminium and delrin, certainly help with rigidity! A littl...
This is how Old Man detailed to me how he would tune cars when his brother and him were racing in SCCA. Old man was the chief of the crew and asked the pilot (his brother, my uncle) to do a run up ...
I wouldn't say 2000+ MAF's are horrible. I have only had one bad one on our SE and that was after 130k miles of use. I have been blowing 9-14psi through a 155k mile one for two years and it is stil...
Sure, Haltech Elite series is maybe the most common one
Is there anymore update on this? Really want to run nemu on my 01 SE.
I think he is referring to plug and play applications. Currently no one making conversion harnesses for the 00+ p11's. Then the stepper motor issue has to be rectified too. That level of wiring is ...
I have something in the works for the 00+ P11's.
"Cowl Induction"
Took it to KC on my birthday, then out to columbia last week. Broke 4,000 miles @ 14psi. Got 30MPG highway!! Getting ready to put her in the garage for a minor teardown. Going to use it for mockup...
https://www.youtube.com/watch?v=4sw6wVt69Bs
Been awhile since I have had a chance to work on the car. Lot of other stuff I needed to take care of before the summer ends... Anyway the car is back together now. I started it up and tried puttin...
need a locksmith to disassemble whatever is the least problematic (i.e. if key works for all doors + trunk but not ignition, ignition needs work)
they will disassemble the entire thing, and rear...