All posts liked by SR20DET_B14
1 |
Very nice. That's a Beefy Bar too.
Chip
Intake air temps before and after intercooler.
If you said putting a front bar on would make it oversteer, then putting on a rear bar would really make it want to oversteer. Be safe.
I've been running no BOV for 2.5 years now and loving it haha :bigthumbup:
Probably not helpful... but me and most of my car friends run no BOV with no issues.
Sounds mean.
Just did a coat of cleaner compound wax and 2 coats of premium wax.
This is my 98 SE-R, original paint! Nissan's superblack color really does hold up well:
http://photos.napalm.net/clubsi/waxedmo...
I also was always under the impression that the VET snail was BB.
C
Yeah, a lot of mixed info out there on everything. One guy says ball bearing and everyone says it without checking... I have actually torn them down and have the coated journal bearings sitting on ...
Yes, they are journal bearing. At least you can rebuild it super cheap :)
They are pretty much the same thing as a GTIR turbo. The difference between the two are trim of the turbine (also 10 blade vs 11 blade) because of the housings .64 VET .86 GTIR. Both are journal be...
I've owned two 2560R's and they were both ball bearing. Loved that little baby on my SE-R and Miata.
C
I have a gauge on order should be here on saturday. So that should answer some questions
On a side note. I took the distributor of today and when I removed the cap I found the rotor retainer...
Did you check the engine coolant temp sensor?
[url= URL=http://www.sr20-forum.com/general-sr20/24921-coolant-temperature-sensor.html#post320991]http://www.sr20-forum.com/general-sr20/24921-coolant...
It kind of sounds like your O2 sensor could be dead. Although I think you may have a few issues. It sounds like your TPS is obviously also toast. You could have a dying fuel pump as well.
When an ...
super slick idea. You get any leakage when the valve is closed?
1 |