BenFenner's Likes Given

No orders yet. I just finished building a couple of welding tables that will help me build these quicker. Should be able to make some progress this weekend :)

http://turbofx.net/wp-content/uploa...

Worked on these over the weekend by prepping a few of the stabilizer bar parts for welding :)

http://turbofx.net/wp-content/uploads/2016/10/Shift-Linkage-Parts-Prepped-for-Welding.jpg

Cut out a bunch of parts for these last Fri. night...next update will be this weekend.

http://turbofx.net/wp-content/uploads/2016/10/Shift-Linkage-CNC-Plasma.jpg

Vvl

New member from South Carolina 2002 P11 G20

Is it just the spring shifting in the perch? Are the springs preloaded or loose at full droop?

A few pics of the last batch taking shape

http://turbofx.net/wp-content/uploads/2016/10/Weld-clean.jpg

http://turbofx.net/wp-content/uploads/2016/10/Weld-prep.jpg

http://turbofx.net/wp-co...

Carbon Fiber connecting rods

https://cdn.meme.am/instances/500x/72603635.jpg

You realize they will stick out badly like crab crawlers, right?

Really? You simply use your eyeballs... And when you do, you will see a 'classifieds' section.

Might have better luck posting in the classified section. GLWS

Clearing the settings worked for me just now...I'm sure it was just me.

Thank you for your support. ;)

:racer:

Depends on the dyno type. But usually whatever gear is closest to 1:1 ratio will give you the most accurate results.

Gearing up for 11 (1st one for Keo) sets of these...knocked out a few of the stabilizer bar bushing holders earlier this week.

http://turbofx.net/wp-content/uploads/2016/10/IMG_20161003_220259-e...

In with the new

The eager feeling has arrived !

Any thing clutch masters and don't look back spend the extra cash. Save the headaches later.

That is why you should only buy clutches from reputable name companies. Trying to save a few bucks never turns out good in the long run with critical parts.

Not going to hide from this at all, I did not intentionally sell a bad turbo nor did I intend to rip blair off. Ran into some hard financial times ( which is why the project got parted out ). I ...

Better chuck mine on here
Also nice work Nismo Sunny ,gotta love the RB26 conversion

http://i1037.photobucket.com/albums/a452/gurrman/smallEB-1.jpg

http://i1037.photobucket.com/albums/a452/...

OK, I had the right sizes above, 10mm square drive for the fill plug, 13mm square drive for the drain plug. Both are male square sockets.

I was able to find the 13mm one at the local NAPA Auto ...

I have this info at home, but I believe the drain was a 13mm, and the fill was a 10mm. I bought them both for around $5 each. Will confirm and update tonight with this info.

Sorry, that's the bit I worried about. I think it might be a 10mm since 3/8 works out to 9.53 mm and that's loose.

...if you can't find any square bits, you can go [url= URL=http://www.frsport.com/Diff---Trans-Magnetic-Drain-Bolt-26mm-Most-Nissan_p_15106.html?gclid=CjwKEAjwmf6-BRDi9fSN7Ijt1wUSJAASawcjZO9LLoAkSW...