Thread: P11/B15 shifter rod and stabilizer for B13/b14 chassis

You're welcome!

I had a jack shoot out from under the cross member while lifting the car once...never did it that way again

Jacking on the engine brace, crushes the lower cross member

pm box full, but my bad dude been a little busy. will try to get it out today or monday the latest.

No worries, I'll be busy w/ the j-pipe build until then...thanks for sending it out!

Cleared the inbox too lol

im not kidding ill take 3 of these. needing one fairly quickly. do you have any idea of when youll have one ready to sell?

I just snipped the last part out today. Sorry for the delay.

Keo shipped the bracket and it's scheduled for delivery this Sat (thanks dude ) . I'll test fit the prototype linkage this weekend, make any necessary changes, and then the first version will be good to go, and I'll finally know pricing. The first version = multiple bends welded together to create the linkage. I want to make the 2nd version one piece, but that'll take a little more R&D.

I just test fit the prototypes and they look like they are good to go. The clearance with these is much better than the grind to fit b13 linkage.



My car doesn't currently run, so I don't have any way to compare how they function vs the modded b13 linkage. Keo, I'll send this set your way so you can give me feedback, sound good?

i actually have another car in piece in the garage and wont be able to test for at least another 2 weeks.