Originally Posted by
nibbz9999 thanks for your response bigben.. as much as i want to modify the xdf but i'm afraid to mess up with it by combining the standard xdf with the LC gtir/ retired timing.. I would appreciate if anyone can help us out i think this could be a very useful to those who are using a chip base ecu..
In regards to the XDF file you sent me.
TinyUpload.com - best file hosting solution, with no limits, totaly free The launch control parameters look like they are correct. As long as you copied over the other parameters from a correct xdf for your engine it should be good. But remember you must use the GTIR LC bin from the other thread as your base and then copy over any maps or parameters that you have modified from your current bin to the LC bin and then rename and save it. The LC bin has modifed code in it that the original bin does not. The LC parameters in your xdf will not make any sense in tunerpro if you load a bin that does not have the modified code in it. (see the first screen shot below LC bin in red boxes, stock bin in green boxes)
One thing I noticed in your xdf though is the consult register parameter is set for the wrong location it should be 1010 not 7F50.
[ATTACH=CONFIG]816[/ATTACH][ATTACH=CONFIG]817[/ATTACH][ATTACH=CONFIG]818[/ATTACH]